Physics, 20.01.2021 01:00, joejoefofana

What is the momentum of a dirt bike with a mass of 112 kg moving 25 m/s?
a. 4.88 kg m/s
b. 87 kg m/s
c. 2800 kg m/s

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 13:40, mvongphakdy8746

Consider a double atwood machine constructed as follows: a mass 4m is suspended from a string that passes over a massless pulley on frictionless bearings. the other end of this string supports a second similar pulley, over which passes a second string supporting a mass of 3m at one end and m at the other. using two suitable generalized coordinates, set up the lagrangian and use the lagrange equations to find the acceleration of the mass 4m when the system is released. explain why the top pulley rotates even though it carries equal weights on each side.

Answers: 2

continue

Physics, 23.06.2019 02:00, jamesnech66

How can you measure the amplitude of a longitudinal wave?

Answers: 2

continue

Physics, 23.06.2019 08:00, weeblordd

Use henry's law and the solubilities given below to calculate the total volume of nitrogen and oxygen gas that should bubble out of 1.7 l of water upon warming from 25 ˚c to 50 ˚c. assume that the water is initially saturated with nitrogen and oxygen gas at 25 ˚c and a total pressure of 1.0 atm. assume that the gas bubbles out at a temperature of 50 ˚c. the solubility of oxygen gas at 50 ˚c is 27.8 mg/l at an oxygen pressure of 1.00 atm. the solubility of nitrogen gas at 50 ˚c is 14.6 mg/l at a nitrogen pressure of 1.00 atm. assume that the air above the water contains an oxygen partial pressure of 0.21 atm and a nitrogen partial pressure of 0.78 atm.

Answers: 2

continue

Physics, 23.06.2019 08:30, lele2010

Industrial processes often require the damping of vibrations. consider a workbench that uses four large ideal springs in place of traditional legs, with each spring supporting one corner of the workbench and exhibiting a force constant of 47500 n/m. this workbench is used when creating products that involve highly unstable chemicals. according to specifications, the acceleration of the manufacturing equipment must be held to less than 22.3 m/s2 for the manufacturing process to proceed safely. the amplitude of vibrations are expected to remain under 0.622 mm throughout. given that the workbench and maufacturing equipment combine to 6.05 kg, find the maximum acceleration expected of the equipment and workbench. (ignore the mass of the springs.)

Answers: 2

continue

Do you know the correct answer?

What is the momentum of a dirt bike with a mass of 112 kg moving 25 m/s?
a. 4.88 kg m/s
...