Consider two object has mass m1=5.0kg m2=0.5kg and the specific heat c1=c2=4200j/kg oc respectively assume that first object has temperature 20oc and second object has temperature 90oc After they place these two object touch each other determine the mixture temperature of the substance

Explanation:

Given

mass of the first object

mass of the second object

specific heat of the two is

The temperature of the first

The temperature of the second

Heat flows from high temperature to low temperature

Suppose T is the common temperature

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).