Physics, 29.12.2020 21:50, benallyadam2067

A light, flexible rope is wrapped several times around a hollow cylinder with a weight of 40 N and a radius of 0.25m that rotates without friction about a fixed horizontal axis. The cylinder is attached to the axle by spokes of a negligible moment of inertia. The cylinder is initially at rest. The free end of the rope is pulled with a constant force P for a distance of 5 m, at which point the end of the rope is moving 6 m/s. If the rope does not slip on the cylinder, what is the value of P

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 20:00, desscraft30

Which of the following represents an upright image? a. -do b. +m c. -m d. +do

Answers: 1

continue

Physics, 21.06.2019 22:00, moneybaggzay123

1. consider the case in which air fills air shocks on a truck trailer. the pressure in the shocks is 2 mpa. the temperature is 300 k. the diameter of the shock piston is 10 cm and the initial length of the cylindrical cavity containing the compressed air is 40 cm. a. the truck is gradually loaded over a period of a day in a static setting. the temperature is held constant for the atmosphere and thus for the gas shock. calculate the compressibility of the air in the shock for this condition when the truck is initially being loaded. b. if the shocks were loaded in a dynamic setting by driving over bumps, what would be the compressibility? state your assumption. c. what is the initial load on the shock if the shock is in an atmospheric 100 kpa? d. if the shock is compressed using the process described in part a, and the air shock compressed air cavity length decreases to 20 cm, what is the additional load applied to the shock?

Answers: 2

continue

Physics, 22.06.2019 02:30, ntangpricha

Eddy whose mass is 55kg climbs up the 1.50 meter high stairs in 2s. calculate eddy’s power rating

Answers: 1

continue

Physics, 22.06.2019 02:50, lilybear1700

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Answers: 3

continue

Do you know the correct answer?

A light, flexible rope is wrapped several times around a hollow cylinder with a weight of 40 N and a...