Physics, 15.12.2020 19:30, jkjjoijjm5928
Two spheres A and B are projected off the edge of a 1.0 m high table with the same horizontal velocity . sphere A has a mass of 20.g and sphere B has a mass of 10.g.
If both spheres leave the edge of the table at the same instant, sphere A will land
a. at some time after sphere B.
b. at the same time as sphere B.
c. at some time before sphere B.
d. There is not enough information to decide.
__ 6. If both spheres leave the edge of the table at the same instant, sphere A hits the floor at the spot marked X. Sphere B will hit the floor
a. at some point between the edge of the table and X.
b. at some point past X.
c. at the same distance from the table as X.
d. there is not enough information to decide.
Answers: 3
Physics, 21.06.2019 22:50, sarahfsakrani
Aplane takes off from an airport and flies to town a, located d1 = 215 km from the airport in the direction 20.0° north of east. the plane then flies to town b, located d2 = 230 km at 30.0° west of north from town a. use graphical methods to determine the distance and direction from town b to the airport. (enter the distance in km and the direction in degrees south of west.)
Answers: 2
Physics, 22.06.2019 14:50, MoogleCaliS
Nitrogen (n2) undergoes an internally reversible process from 6 bar, 247°c during which pν1.2 = constant. the initial volume is 0.1 m3 and the work for the process is 121.14 kj. assuming ideal gas behavior, and neglecting kinetic and potential energy effects, determine heat transfer, in kj, and the entropy change, in kj/s. show the process on a t-s diagram.
Answers: 2
Physics, 23.06.2019 07:00, hockejoh000
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater. what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
Two spheres A and B are projected off the edge of a 1.0 m high table with the same horizontal veloci...
History, 20.05.2021 23:20
History, 20.05.2021 23:20
Mathematics, 20.05.2021 23:20
Mathematics, 20.05.2021 23:20