Physics
Physics, 14.12.2020 16:30, lol6998

The question is on the picture


The question is on the picture

answer
Answers: 1

Other questions on the subject: Physics

image
Physics, 22.06.2019 02:30, coltonstevens15
Which feature of a heating curve indicates a change ofn state
Answers: 1
image
Physics, 22.06.2019 10:20, brandon1888
Asmall object with mass 0.200 kg swings back and forth on the lower end of a light rope that is 3.00 m long. the upper end of the rope is attached to the ceiling. as the object swings through its lowest position, where the rope is vertical, the speed of the object is 5.80 m/s. at this point in the motion, what is the tension in the rope? (use g = 9.80 m/s2.)
Answers: 2
image
Physics, 22.06.2019 16:00, blythephillips2734
An charge with mass m and charge q is emitted from the origin, (x, y)=(0,0). a large, flat screen is located at x=l. there is a target on the screen at y position y(h), where y(h) > 0. in this problem, you will examine two different ways that the charge might hit the target. ignore gravity in this problem. 1.assume that the charge is emitted with velocity v(0) in the positive x direction. between the origin and the screen, the charge travels through a constant electric field pointing in the positive y direction. what should the magnitude e of the electric field be if the charge is to hit the target on the screen? express your answer in terms of m, q, y(h), v(0), and l. 2.now assume that the charge is emitted with velocity v(0) in the positive y direction. between the origin and the screen, the charge travels through a constant electric field pointing in the positive x direction. what should the magnitude e of the electric field be if the charge is to hit the target on the screen? express your answer in terms of m, q, y(h), v(0), and l.
Answers: 1
image
Physics, 22.06.2019 18:00, maren17
Air enters a gas turbine with two stages of compression and two stages of expansion at 100 kpa and 17°c. this system uses a regenerator as well as reheating and intercooling – the intercooler returns the air to the inlet temperature. the pressure ratio across each compressor is 4 ; 300 kj/kg of heat are added to the air in each combustion chamber; and the regenerator operates perfectly while increasing the temperature of the cold air by 20°c. determine the system’s thermal efficiency. assume isentropic operations for all compressor and the turbine stages and use constant specific heats at room temperature. (0.378)
Answers: 3
Do you know the correct answer?
The question is on the picture
...

Questions in other subjects:

Konu
Mathematics, 02.03.2021 06:40