Physics
Physics, 07.12.2020 21:40, jaallen3679

what happens to the electric force if the magnitude of both charges in an electrostatic interaction is tripled

answer
Answers: 3

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:50, Bt758
Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.
Answers: 2
image
Physics, 22.06.2019 13:40, mvongphakdy8746
Consider a double atwood machine constructed as follows: a mass 4m is suspended from a string that passes over a massless pulley on frictionless bearings. the other end of this string supports a second similar pulley, over which passes a second string supporting a mass of 3m at one end and m at the other. using two suitable generalized coordinates, set up the lagrangian and use the lagrange equations to find the acceleration of the mass 4m when the system is released. explain why the top pulley rotates even though it carries equal weights on each side.
Answers: 2
image
Physics, 22.06.2019 17:40, kimberly01262016
The weights of bags filled by a machine are normally distributed with a standard deviation of 0.05 kilograms and a mean that can be set by the operator. at what level should the mean weight be set if it required that only 1% of the bags weigh less than 9.5 kilograms? round the answer to 2 decimal places.
Answers: 1
image
Physics, 22.06.2019 20:30, mooreadrian412
You are doing a science experiment with a fahrenheit thermometer. your data must be in degrees celsius. if you measure a temperature of 125°f, what is this temperature in degrees celsius
Answers: 1
Do you know the correct answer?
what happens to the electric force if the magnitude of both charges in an electrostatic interaction...

Questions in other subjects: