Physics
Physics, 18.11.2020 01:00, cocoj3205

A truck going 70 m/s crashes in to a wall and comes to a complete stop in .05 seconds. What is the acceleration of the truck? Group of answer choices

answer
Answers: 3

Other questions on the subject: Physics

image
Physics, 21.06.2019 17:00, ijohnh14
Which statement best describes who the period and frequency of electromagnetic was change between gamma rays and microwaves? a) the period and frequency stay the same. b) the period increases and the frequency decreases. c) the period decreases and the frequency increases. d) the period increases and the frequency increases.
Answers: 2
image
Physics, 21.06.2019 20:40, cuavang55
In a steady-flow steam power plant system, two adiabatic high-pressure and low-pressure turbines ane used to generate power. superheated steam enters the high-pressure turbine at 8 mpa and 550°c. the steam expands in the high-pressure turbine to a saturated vapor at 3 mpa. in order to increase the powe generation of the power plant, another steam turbine working in a lower pressure ranges is deployed. the outlet vapor from the first turbine is heated up at a boiler to the temperature of 500 c at the constant pressure of first turbine's outlet (3 mpa). then, the vapor enters the second turbine and produces extra work. the exit conditions of the second turbine are 5o kpa and 90 percent quality. if the total power output of the power plant is 25 mw, determine a) the mass flow rate of the water (kg/s). b) heat transfer rate in the boiler (mw). (30 points) 3 mpa 00 c 8 mpa s0 c high pres turbine low pres boiler turbine 50 kpa 3 mpa 09 saturated vapor t heat engine, shown in the figure, operates between high temperature and low temperature of through a heat 4. a carnot tn and tu respectively. this heat engine receives energy from a heat reservoir at t exchanger where the heat transferred is proportional to the temperature difference as ? = k (z,-7, ). it rejects heat at a given low temperature tl. to design the heat engine for maximum work output, find the high temperature, th, as a function of tes and t. (15 points) qe
Answers: 3
image
Physics, 22.06.2019 00:30, ddea4081
Ablock of steel has a density of 0.29lbs per cubic inch. if the block has dimensions of 1 inch by 1 inch by 3 inches, what is its weight? a. 0.29lbs b. 0.58lbs c. 0.87lbs d. 1lbs
Answers: 1
image
Physics, 22.06.2019 18:30, natperal
Aheavy piece of hanging sculpture is suspended by a90-cm-long, 5.0 g steel wire. when the wind blows hard, the wire hums at its fundamental frequency of 80hz. what is the mass of the sculpture?
Answers: 3
Do you know the correct answer?
A truck going 70 m/s crashes in to a wall and comes to a complete stop in .05 seconds. What is the a...

Questions in other subjects:

Konu
Physics, 15.04.2020 23:01