Physics
Physics, 09.11.2020 01:00, alexis24852

There are ways to identify a chemical change?

answer
Answers: 3

Other questions on the subject: Physics

image
Physics, 21.06.2019 16:30, yousifgorgees101
Which of the following would not be taken into consideration when describing the quality of a sound
Answers: 2
image
Physics, 21.06.2019 21:30, yfnal3x
How many seconds does it take a pebble released from rest off a bridge to fall 29.4 m ? what is the pebble's speed when it has fallen 29.4 m ?
Answers: 1
image
Physics, 21.06.2019 22:00, natethawsm
Na food processing facility, a spherical container of inner radius r1 5 40 cm, outer radius r2 5 41 cm, and ther- mal conductivity k 5 1.5 w/m · k is used to store hot water and to keep it at 100°c at all times. to accomplish this, the outer surface of the container is wrapped with a 800-w electric strip heater and then insulated. the temperature of the inner surface of the container is observed to be nearly 120°c at all times. as- suming 10 percent of the heat generated in the heater is lost through the insulation, (a) express the differential equation and the boundary conditions for steady one-dimensional heat conduction through the container, (b) obtain a relation for the variation of temperature in the container material by solving the differential equation, and (c) evaluate the outer surface tempera- ture of the container. also determine how much water at 100°c this tank can supply steadily if the cold water enters at 20°c.
Answers: 2
image
Physics, 22.06.2019 01:10, joejoefofana
Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?
Answers: 3
Do you know the correct answer?
There are ways to identify a chemical change?...

Questions in other subjects:

Konu
English, 02.09.2019 12:50
Konu
History, 02.09.2019 12:50