Tosing Lotal =
As the simulation runs, the time is displayed at the top of the
Interactive. If the Pause button is pressed, arrows appear
next to the time to step the simulation forward or backward.
Use these controls to measure the time it takes to rise to the
peak, the total time in the air, and the time it takes to fall from
the peak. Record to the ONE decimal place.
talling

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

Which of the following is an example of units for speed

Engineers find a new metal that is stronger than steel but much lighter. this material is also significantly cheaper than what is currently used for most aircraft, available in large quantities, and easy to manufacture. the engineers are excited because this new material will lower the costs of buying and operating airplanes for companies. what is probably the best step for the engineers to make next?