Physics
Physics, 28.10.2020 01:40, mjwilliams6

How do I proton and and electron compared

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 20:30, milhai0627a
Asmall metal bar, whose initial temperature was 10° c, is dropped into a large container of boiling water. how long will it take the bar to reach 70° c if it is known that its temperature increases 2° during the first second? (the boiling temperature for water is 100° c. round your answer to one decimal place.) sec how long will it take the bar to reach 98° c? (round your answer to one decimal place.)
Answers: 2
image
Physics, 22.06.2019 00:00, faithcalhoun
How do the measurements of charge at the different locations on the sphere compare to each other? the charge measurements are different at all locations on the sphere. the charge measurements are virtually not the same at all locations on the sphere except for the charge at the very top and at the very bottom that are equal. the charge measurements are virtually the same at all locations on the sphere except for the charge at the very top. at the top, the conductive sphere has a small disk that is made of different material. the charge measurements are the same at all locations on the sphere. what happens to the charge on the conductive sphere when it is connected to a source of charge such as the electrostatic voltage source? nothing will happen because no charge goes around the surface of the sphere. the charge on the conductive sphere spreads out over the surface of the sphere; being greater in some specific locations on the sphere. the charge on the conductive sphere spreads out uniformly over the surface of the sphere. the charge on the conductive sphere spreads out non-uniformly over the surface of the sphere.
Answers: 3
image
Physics, 22.06.2019 04:40, ortega103
Steam enters an adiabatic diffuser at 150 kpa and 1208c with a velocity of 550 m/s. determine the minimum velocity that the steam can have at the outlet when the outlet pressure is 300 kpa.
Answers: 3
image
Physics, 22.06.2019 12:50, shollydot1379
Assume you measured the mass of the cart to be (500 ± 1) g and the mass of the additional mass you put on the cart to be (500 ± 1) g as well. since the scale you are using in the lab cannot measure objects heavier than 600g you will have to sum up individual pieces and propagate the error. so what would be the mass and the standard error of the cart and the mass
Answers: 3
Do you know the correct answer?
How do I proton and and electron compared...

Questions in other subjects: