Physics, 28.09.2020 02:01, xeskimopie

Use your answers from questions 9-11 as the basis for the fourth section of your lab report. In this section, you will summarize the outcome of the experiment, and discuss how the original hypothesis(es) was (were) either supported or refuted. Use logic and reason in explaining your statements, and be sure to refer to specific data from your experiment that supports your argument. This section also demonstrates your understanding of the experiment, through your ability to offer constructive criticism about its design and make suggestions for future experimentation. There are always ways that experiments can be improved. Now that you are a veteran of this experiment and have experience with the procedure, offer some advice to the next scientist about what you suggest and why.

At least one para.

9.What do the results tell you about your hypothesis(es)?
10.How do the data support your claim above?
11.If you could repeat the experiment and make it better, what would you do differently and why?

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 20:30, trenrain

When you drop a pebble from height a it reaches the ground with speed v if there is no air resistance. from what height should you drop it so it will reach the ground with three times the speed? (a) 9m (b) 3m (c) 6m (d) 18m

Answers: 2

continue

Physics, 21.06.2019 22:00, moneybaggzay123

1. consider the case in which air fills air shocks on a truck trailer. the pressure in the shocks is 2 mpa. the temperature is 300 k. the diameter of the shock piston is 10 cm and the initial length of the cylindrical cavity containing the compressed air is 40 cm. a. the truck is gradually loaded over a period of a day in a static setting. the temperature is held constant for the atmosphere and thus for the gas shock. calculate the compressibility of the air in the shock for this condition when the truck is initially being loaded. b. if the shocks were loaded in a dynamic setting by driving over bumps, what would be the compressibility? state your assumption. c. what is the initial load on the shock if the shock is in an atmospheric 100 kpa? d. if the shock is compressed using the process described in part a, and the air shock compressed air cavity length decreases to 20 cm, what is the additional load applied to the shock?

Answers: 2

continue

Physics, 22.06.2019 05:30, ninaaforever

Aforklift raises a 1,020 n crate 3.50 m up to a shelf. how much work is done by the forklift on the crate? the forklift does j of work on the crate.

Answers: 2

continue

Physics, 22.06.2019 08:00, cia196785920

If a balloon is taken outside on a very cold day, what will occur?

Answers: 1

continue

Do you know the correct answer?

Use your answers from questions 9-11 as the basis for the fourth section of your lab report. In this...