Physics
Physics, 22.09.2020 01:01, hopkinsgail5516

De donde eres en realidad y doy corona

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 20:40, cuavang55
In a steady-flow steam power plant system, two adiabatic high-pressure and low-pressure turbines ane used to generate power. superheated steam enters the high-pressure turbine at 8 mpa and 550°c. the steam expands in the high-pressure turbine to a saturated vapor at 3 mpa. in order to increase the powe generation of the power plant, another steam turbine working in a lower pressure ranges is deployed. the outlet vapor from the first turbine is heated up at a boiler to the temperature of 500 c at the constant pressure of first turbine's outlet (3 mpa). then, the vapor enters the second turbine and produces extra work. the exit conditions of the second turbine are 5o kpa and 90 percent quality. if the total power output of the power plant is 25 mw, determine a) the mass flow rate of the water (kg/s). b) heat transfer rate in the boiler (mw). (30 points) 3 mpa 00 c 8 mpa s0 c high pres turbine low pres boiler turbine 50 kpa 3 mpa 09 saturated vapor t heat engine, shown in the figure, operates between high temperature and low temperature of through a heat 4. a carnot tn and tu respectively. this heat engine receives energy from a heat reservoir at t exchanger where the heat transferred is proportional to the temperature difference as ? = k (z,-7, ). it rejects heat at a given low temperature tl. to design the heat engine for maximum work output, find the high temperature, th, as a function of tes and t. (15 points) qe
Answers: 3
image
Physics, 22.06.2019 03:50, ash011519
The force acting on a beam was measured under the same operating conditions and a sample of 5 data points was collected. this process was repeated by 3 observers. the pooled standard deviations of these 3 data sets was 1.21. determine the true mean force using all pooled data (with a 95% probability). the result should look like this: true mean = mean +/- margin of error
Answers: 1
image
Physics, 22.06.2019 11:50, stdias
Find the dimensions and area of the largest rectangle that can be inscribed in the upper half of the ellipse. (give your answers in terms of a and b. enter the dimensions as a comma-separated list.)
Answers: 2
image
Physics, 22.06.2019 20:00, rosepotato789
Choose a realistic problem for which these are the correct freebody diagrams. be sure that the answer that the problem requests is consistent with the diagrams shown. choose a realistic problem for which these are the correct freebody diagrams. be sure that the answer that the problem requests is consistent with the diagrams shown. a 1.0 kg block is placed on top of a 2.0 kg block. a horizontal rope pulls the 2.0 kg block across a frictionless floor with a force of 21.0 n. the coefficient between the two blocks is 0.75. does the 1.0 kg block on top slide?
Answers: 3
Do you know the correct answer?
De donde eres en realidad y doy corona...

Questions in other subjects: