Physics
Physics, 13.07.2020 15:01, Mypasswordishotdog11

Label the parts of a concave lens. 1:

2

2:

3

41

2F

F

F

2F

4

answer
Answers: 1

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:00, homework2358
There is a theory that indicates that dinosaurs became extinct when about 65 million years ago, a large asteroid hit the earth surface. dust caused by this collision blocked the sunlight reaching the earth's surface and many forms of life became extinct due to the cold. fearing this threat, how large the radius of an asteroid should you be looking for if the dangerous asteroid size is approximately the same as the one that killed the dinosaurs? available data suggests that about 18% of that asteroid's mass ended up as a dust spread evenly over earth after eventually settling out of the upper atmosphere. about 0.0180 g/cm^2 of dust, which is chemically different than the earth's rock, covered the earth's surface. typical asteroids have a density of about 1.9 g/cm^3. now that we know the size of the asteroid, how much energy was released during impact, assuming all of it was just the kinetic energy of the asteroid right before the impact?
Answers: 1
image
Physics, 22.06.2019 00:00, anna40794
(science)study the following ocean currents map. an ocean currents map is shown. on the map the locations for san diego, california and savannah, georgia are marked. there is a looping current from the north past san diego and a looping current from the south near savannah which statement is most likely correct about the average temperatures in san diego, california as compared to savannah, georgia? it is higher in savannah because of the cool ocean currents from the south. it is higher in savannah because of the warm ocean currents from the north. it is lower in san diego because of the warm ocean currents from the south. it is lower in san diego because of the cool ocean currents from the north.
Answers: 2
image
Physics, 22.06.2019 05:30, mlopezmanny5722
The a992 steel rod bc has a diameter of 50 mm and is used as a strut to support the beam. determine the maximum intensity w of the uniform distributed load that can be applied to the beam without risk of causing the strut to buckle. take f. s. = 2 against bucklin
Answers: 3
image
Physics, 22.06.2019 18:00, iaminu50
A4.0-cm tall light bulb is placed a distance of 32.0 cm from a concave mirror having a focal length of 16.0 cm. determine the image distance
Answers: 1
Do you know the correct answer?
Label the parts of a concave lens. 1:

2

2:

3

41

Questions in other subjects:

Konu
Mathematics, 23.02.2020 00:23
Konu
Mathematics, 23.02.2020 00:24