1. Take the speed at which the body moves as 10 m/s 2. Calculate the distance travelled by the body every second 3. Take the time on the x-axis and distance travelled on the y-axis 4. Plot the distance vs time graph on a centimeter graph sheet taking 1cm= 1 s 5. Repeat the steps 2-4 for a speed of 50 m/s on the same graph sheet 6. Observe the graphs obtained for different speeds a) Find the nature of the graph obtained b) What kind of motion is obtained- uniform/non-uniform?

a)this graph is also a line     b) in both cases we have a uniform movement

Explanation:

In this exercise we have a uniform movement

     v = d / t

     d = v t

in the table we give some values to make the graph

       t (s)    d (m)

        1         10

        2        20

        3         30

In the attached we can see the graph that is a straight line

we have another vehicle at v = 50 me / S

t (s)     d (m)

1         50

2        100

3         150

this graph is also a line

b) in both cases we have a uniform movement

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

because growing process had stoped after 4-5 year