Physics, 19.06.2020 11:57, austinkellylay
4. Describe how you would make or conduct a wet cell. What basic part would you need? How would you use them to produce a voltage?
Answers: 3
Physics, 22.06.2019 01:00, anna4060
First, launch the video below. you will be asked to use your knowledge of physics to predict the outcome of an experiment. then, close the video window and answer the question at right. you can watch the video again at any point. part a as in the video, we apply a charge +q to the half-shell that carries the electroscope. this time, we also apply a charge –q to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? view available hint(s) as in the video, we apply a charge + to the half-shell that carries the electroscope. this time, we also apply a charge – to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? it deflects more than it did at the end of the video. it deflects the same amount as at end of the video. it does not deflect at all. it deflects less than it did at the end of the video. submit
Answers: 2
Physics, 22.06.2019 16:50, Jstylez1789
Consider the growth of a 20-nm-diameter silicon nanowire onto a silicon wafer. the temperature of the wafer surface is maintained at 2400 k. assume the thermal conductivity of the silicon nanowire is 20 wm-1k-1 and all its surfaces including the tip are subjected to convection heat transfer with the coefficient h = 1×105 wm-2k-1 and t∞ = 8000 k. when the nanowire grows to l = 300 nm, what is the temperature of the nanowire tip (t (x =
Answers: 1
Physics, 22.06.2019 23:00, aliyyahlove
Awelder using a tank of volume 7.50×10^-2 m^3 fills it with oxygen (with a molar mass of 32.0 g/mol ) at a gauge pressure of 3.30×10^5 pa and temperature of 37.1 ∘c. the tank has a small leak, and in time some of the oxygen leaks out. on a day when the temperature is 23.1 ∘c, the gauge pressure of the oxygen in the tank is 2.00×10^5 pa . a) find the initial mass of oxygen. b) find the mass of oxygen that has leaked out.
Answers: 3
4. Describe how you would make or conduct a wet cell. What basic part would you need?
How would you...
Advanced Placement (AP), 24.11.2019 10:31
Mathematics, 24.11.2019 10:31
History, 24.11.2019 10:31
Mathematics, 24.11.2019 10:31
History, 24.11.2019 10:31
Mathematics, 24.11.2019 10:31