Physics
Physics, 30.05.2020 23:03, aaronolivera200161

Tech A says that a voltage drop of 0.8 volts on the starter ground circuit is within specifications. Tech B says that high starter draw current could be caused by a spun main bearing in the engine. Who is correct

answer
Answers: 1

Other questions on the subject: Physics

image
Physics, 21.06.2019 20:40, cuavang55
In a steady-flow steam power plant system, two adiabatic high-pressure and low-pressure turbines ane used to generate power. superheated steam enters the high-pressure turbine at 8 mpa and 550°c. the steam expands in the high-pressure turbine to a saturated vapor at 3 mpa. in order to increase the powe generation of the power plant, another steam turbine working in a lower pressure ranges is deployed. the outlet vapor from the first turbine is heated up at a boiler to the temperature of 500 c at the constant pressure of first turbine's outlet (3 mpa). then, the vapor enters the second turbine and produces extra work. the exit conditions of the second turbine are 5o kpa and 90 percent quality. if the total power output of the power plant is 25 mw, determine a) the mass flow rate of the water (kg/s). b) heat transfer rate in the boiler (mw). (30 points) 3 mpa 00 c 8 mpa s0 c high pres turbine low pres boiler turbine 50 kpa 3 mpa 09 saturated vapor t heat engine, shown in the figure, operates between high temperature and low temperature of through a heat 4. a carnot tn and tu respectively. this heat engine receives energy from a heat reservoir at t exchanger where the heat transferred is proportional to the temperature difference as ? = k (z,-7, ). it rejects heat at a given low temperature tl. to design the heat engine for maximum work output, find the high temperature, th, as a function of tes and t. (15 points) qe
Answers: 3
image
Physics, 22.06.2019 02:00, honeybaby675610
Askydiver weighing 140 lb (including equipment) falls vertically downward from an altitude of 19,000 ft and opens the parachute after 18 s of free fall. assume that the force of air resistance, which is directed opposite to the velocity, is of magnitude 0.55|v| when the parachute is closed and is of magnitude 14|v| when the parachute is open, where the velocity v is measured in ft/s. assume that acceleration due to gravity has magnitude 32 ft/s/s; remember that weight is the product of mass and gravitational acceleration. (a) find the speed of the skydiver when the parachute opens. (b) find the distance fallen before the parachute opens. (c) what is the limiting velocity vl after the parachute opens? (d) determine how long the sky diver is in the air after the parachute opens. (e) plot the graph of velocity versus time from the beginning of the fall until the skydiver reaches the ground.
Answers: 1
image
Physics, 22.06.2019 12:00, louieknown
Suppose a wire with a current is pushed upward by a magnetic field. how would the wire move if the direction of the current reversed? explain your answer.
Answers: 1
image
Physics, 22.06.2019 15:30, bloodry
Two point charges are separated by a certain distance. how does the strength of the electric field produced by the first charge, at the position of the second charge, change if the second charge is doubled? a. the field does not change b. the field strength decreases by half. c. the field strength doubles d. the field strength quadruples
Answers: 1
Do you know the correct answer?
Tech A says that a voltage drop of 0.8 volts on the starter ground circuit is within specifications....

Questions in other subjects: