Physics, 12.05.2020 05:57, MJyoungboy

Write a program which selects two integer numbers randomly, adds the numbers and asks the user to enter the answer and then checks if the answer is correct or not. in python

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 10:30, zoebtharpe

An insulated 40 ft^3 rigid tank contains air at 50 psia and 120°f. a valve connected to the tank is now opened, and air is allowed to escape until the pressure inside drops to 25 psia. the air temperature during this process is kept constant by an electric resistance heater placed in the tank. determine the electrical work done during this process.

Answers: 2

continue

Physics, 22.06.2019 19:50, carlinryan

An electron moves with a constant horizontal velocity of 3.0 × 106 m/s and no initial vertical velocity as it enters a deflector inside a tv tube. the electron strikes the screen after traveling 26 cm horizontally and 19 cm vertically upward with no horizontal acceleration. what is the constant vertical acceleration provided by the deflector? (the effects of gravity can be ignored.)

Answers: 2

continue

Physics, 22.06.2019 21:10, alexiaalfaro

The junction rule describes the conservation of which quantity? note that this rule applies only to circuits that are in a steady state.

Answers: 1

continue

Physics, 22.06.2019 21:40, iancuteodora30

Ahair dryer is basically a duct in which a few layers of electric resistors are placed. a small fan pulls the air in and forces it through the resistors where it is heated. air enters a 1200 w hair dryer at 100 kpa and 22°c and leaves at 47°c. the cross-sectional area of the hair dryer at the exit is 60 cm2. neglecting the power consumed by the fan and the heat losses through the walls of the hair dryer, determine (a) the volume flow rate of air at the inlet and (b) the velocity of the air at the exit.

Answers: 1

continue

Do you know the correct answer?

Write a program which selects two integer numbers randomly, adds the numbers and asks the user to en...