Laser light of wavelength 510 nm is traveling in air andshines at normal incidence onto the flat end of a transparent plasticrod that has n = 1.30. The end of the rod has a thin coating ofa transparent material that has refractive index 1.65. Whatis theminimum (nonzero) thickness of the coating (a) for which thereis maximum transmission of the light into the rod; (b) for whichtransmission into the rod is minimized?

A33.1 g copper object is launched from a 1.5 m 30° steel incline positioned on the floor by being pulled up a string attached to a 50.0 g mass suspended vertically over a pulley. the object is projected towards a glass table where it lands when it is at the point along its trajectory with the lowest speed. it comes to a halt when it clears the opposite edge of the table. it then falls and lands on 9 physics texts each 5 cm thick that are stacked on the floor on the opposite side of the table. assume that the table does not have a ledge and the rectangular object experiences 0.05 n of air resistance as it falls towards the books. how far and how long did the object travel and how fast does it hit the books. assume that at the moment the copper object leaves the incline, the massless string and ideal pulley break off

Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.

Which of the choices below is one of the primary gases found in the atmosphere? a. helium b. carbon dioxide c. nitrogen d. argon