Physics
Physics, 05.05.2020 20:30, taylormjensen

1

Deionized water does not conduct electricity because it lacks ions, or charged particles. However, if a little table salt (NaCl) is added to deionized water, the resulting solution will conduct electricity.

What could be done to increase the conductivity of a salt water solution even further?

A.

add more salt to the water

B.

double the amount of both salt and water

C.

add more water

D.

remove salt from the water

( ._.)

answer
Answers: 3

Other questions on the subject: Physics

image
Physics, 22.06.2019 19:30, beth999
Select light for the type of wave, adjust the wavelength so that the light is red, and increase the amplitude of the light to the max. then, select the start button at the source location to begin producing the waves. light is a form of electromagnetic wave, containing oscillating electric and magnetic fields. the wave amplitude detector mentioned above shows how the electric field oscillates in time at the location of the probe. the amplitude of the wave at the location of the probe is equal to the maximum electric field measured. how does the amplitude of the wave depend on the distance from the source?
Answers: 2
image
Physics, 22.06.2019 21:30, LucidDreamer16
What describes the formation of horizon b? a. forms at the surface b. features parent material c. undergoes the most change d. forms due to decomposed material i think the answer is c. undergoes the most change
Answers: 1
image
Physics, 23.06.2019 07:00, hockejoh000
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater. what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
image
Physics, 23.06.2019 10:00, Riplilpeep
4. a car with a mass of 2,200 kg can accelerate from 0 to 30 m/s in 6 seconds. a. assuming all of the force generated by the engine goes into acceleration of the car, how much force is the engine producing? show your work. (6 points)
Answers: 1
Do you know the correct answer?
1

Deionized water does not conduct electricity because it lacks ions, or charged particle...

Questions in other subjects:

Konu
Mathematics, 19.12.2019 19:31