Out of
A bolted butt joint is shown. The diameter of bolts is 2 cm. The width and the thickness of the plates are as shown in the figure. Determine
the safe load Q that can be applied to the joint.
The allowable stresses are as follows:
Bolts: Allowable shear stress for bolts = 0.96 Ucm2
Plates: Allowable bearing stress for plates = 1.5 t/cm2
Allowable tensile stress for plates = 1.4 cm2
Plate of thickness 1.5 cm
Choose...
Failure due to bolt
shear (ton)
Bearing failure of
bolt or plate
(compression
failure) (ton)
Choose
:
Splice plates of
thickness 0.8 cm
Plate tensile (ton)
Choose
3 633 6 3 cm
ТАст
+
Finish attempt

Scientists use laser range-finding to measure the distance to the moon with great accuracy. a brief laser pulse is fired at the moon, then the time interval is measured until the "echo" is seen by a telescope. a laser beam spreads out as it travels because it diffracts through a circular exit as it leaves the laser. in order for the reflected light to be bright enough to detect, the laser spot on the moon must be no more than 1.0 km in diameter. staying within this diameter is accomplished by using a special large-diameter laser. part a if λ = 540nm , what is the minimum diameter of the circular opening from which the laser beam emerges? the earth-moon distance is 384,000 km. express your answer to two significant figures and include the appropriate units.

The ultracentrifuge is an important tool for separating and analyzing proteins. because of the enormous centripetal accelerations, the centrifuge must be carefully balanced, with each sample matched by a sample of identical mass on the opposite side. any difference in the masses of opposing samples creates a net force on the shaft of the rotor, potentially leading to a catastrophic failure of the apparatus. suppose a scientist makes a slight error in sample preparation and one sample has a mass 10 mg larger than the opposing sample. if the samples are 12 cm from the axis of the rotor and the ultracentrifuge spins at 70,000 rpm, what is the magnitude of the net force on the rotor due to the unbalanced samples? ( be thorough on your answer)

Achild has maximum walking speed of 1.6 m/s. what is the length of the child's legs? 0.26 m