Physics, 05.05.2020 03:12, alex7078

PUIuld
Q = mcAT
100.0 g of water is heated from 4.0 degree Cto temperature is 37 degrees C. If the specific heat of water is 4.18 J/gºC, calculate the
amount of heat energy needed to cause this rise in temperature.
Units are already included (please just type in the number)
Round your answer to the nearest whole number.
Blank 1:
Question 17 (2 points)
Formula
Q = mAT
75 g of water is is heated from 0 °C to 100 °C. The specific heat of water is 4.18 J/gºC. Calculate the amount of heat energy needed
to cause this rise in temperature,
Units are already included (please just type in the number)
* Round your answer to the nearest whole number.*
Blank 1:

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 15:30, Animallover100

Which of the following represents a virtual image?

Answers: 1

continue

Physics, 22.06.2019 10:30, zoebtharpe

An insulated 40 ft^3 rigid tank contains air at 50 psia and 120°f. a valve connected to the tank is now opened, and air is allowed to escape until the pressure inside drops to 25 psia. the air temperature during this process is kept constant by an electric resistance heater placed in the tank. determine the electrical work done during this process.

Answers: 2

continue

Physics, 22.06.2019 19:40, mcmccann4317

It may seem strange that the selected velocity does not depend on either the mass or the charge of the particle. (for example, would the velocity of a neutral particle be selected by passage through this device? ) the explanation of this is that the mass and the charge control the resolution of the device--particles with the wrong velocity will be accelerated away from the straight line and will not pass through the exit slit. if the acceleration depends strongly on the velocity, then particles with just slightly wrong velocities will feel a substantial transverse acceleration and will not exit the selector. because the acc

Answers: 1

continue

Physics, 22.06.2019 20:50, dondre54

Asquare 1m x 1m plate is shown below. all four of its edges are kept at 0 co. at t=0the temperature distribution is given by: y xtsins n75)=.a) using separation of variables determine the temperature distribution t(x, y,t)along the plate at any time t. b) discretize the heat conduction equation +=22222 txtusing a second-order centered difference scheme for the two second derivatives and a first-order forward euler scheme for the first derivative. using von neumann stability analysis, determine the stability criterion for the proposed discretization scheme in terms of , hand t. solve for the maximum allowable time step tmax

Answers: 1

continue

Do you know the correct answer?

PUIuld
Q = mcAT
100.0 g of water is heated from 4.0 degree Cto temperature is 37 degrees...