Physics
Physics, 05.05.2020 07:21, jacobd578

In order to heat a large block of iron, you place a smaller, hot block of iron next to it. Initially, the large block of Fe is at room temperature (295 K) and the small block of Fe is at 700 K. Assume that the system (both blocks) is in thermal isolation from the surroundings. As you have seen, the entropy of a system is a function of the number of ways there is to arrange all of the energy in that system.
Consider the following situations:
i) All of the thermal energy is found in the large Fe block.
ii) All of the thermal energy is found in the small Fe block.
iii) There is an equal amount of thermal energy in the large Fe block as there is in the small Fe block.
iv) The average energy per Fe atom in the large block is equal to the average energy per Fe atom in the small block.
Determine:
(a) Which situation is associated with the largest number of ways to arrange the total energy in the system? Which is associated with the fewest number of ways to arrange the energy? Are any of these situations associated with the same number of ways to arrange the energy?
(b) Would any of the above situations be a violation of the Energy Principle? Why or why not?
(c) If you leave the two blocks in contact until the system reaches thermal equilibrium, what can be said about the system?

a) The final temperature of the large iron block is less than the final temperature of the small iron block.
b) The entropy of the total system has increased.
c) The entropy of just the small iron block has remained the same.
d) The total energy of the system has decreased.
e) All of the above.

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 22.06.2019 03:30, annikacorrea
Calculate the mass of an object that has a momentum of 100kg x m/sec and velocity of 4 m/sec
Answers: 1
image
Physics, 22.06.2019 09:00, atsuedem974
Chemical energy is a form of energy. a. heat b. kinetic c. potential d. electromagnetic
Answers: 2
image
Physics, 22.06.2019 14:30, makylahoyle
You can decrease the resistance of a length of wire by
Answers: 2
image
Physics, 22.06.2019 23:00, harlon852
In which of these cases are the two wave points considered to be in phase with each other?
Answers: 1
Do you know the correct answer?
In order to heat a large block of iron, you place a smaller, hot block of iron next to it. Initially...

Questions in other subjects:

Konu
Mathematics, 05.08.2021 06:30
Konu
Computers and Technology, 05.08.2021 06:30
Konu
Mathematics, 05.08.2021 06:30