Which statement describes gravity? Select three options.
There is no defined unit of measureme...
![Physics](/tpl/images/cats/fizika.png)
Physics, 21.04.2020 04:24, tommybear989
Which statement describes gravity? Select three options.
There is no defined unit of measurement for gravity
Gravity is the force that pulls objects toward Earth's center.
Objects that have a small mass will have no gravitational pull.
Gravitational pull between two objects increases as the mass of one increases.
Gravitational pull decreases when the distance between two objects increases.
![answer](/tpl/images/cats/otvet.png)
Answers: 3
Other questions on the subject: Physics
![image](/tpl/images/cats/fizika.png)
Physics, 22.06.2019 11:30, Gigglygoose4181
1. a camcorder has a power rating of 19 watts. if the output voltage from its battery is 7 volts, what current does it use?answer units 2. a 1.5m wire carries a 6 a current when a potential difference of 57 v is applied. what is the resistance of the wire? yourunits 3. a clothes dryer uses about 2 amps of current from a 240 volt line. how much power does it use? yourunits 4.
Answers: 1
![image](/tpl/images/cats/fizika.png)
Physics, 22.06.2019 18:30, breiajr
Aballoon is rising vertically upwards at a velocity of 10m/s. when it is at a height of 45m from the ground, a parachute bails out from it. after 3s he opens his parachute and decelerates ata a constant rate 5m/s. when. (a) what was the height of the parachutist above the ground when he opened his parachute? (b)how far is the parachutist from the balloon at t=3s? (c)with what velocity does the parachutist hit the ground? (d)after how long does the parachutist hit the ground after his exist from the balloon?
Answers: 3
![image](/tpl/images/cats/fizika.png)
Physics, 22.06.2019 18:50, mariposa91
Avertical clean glass piezometer tube has an inside diameter of d = 1 mm and is used to measure pressure in a horizontal pipe carrying water as shown. due to pressure in the pipe, the water at 20c rises into the tube to a height h. if the water pressure in the pipe is p = 500 pa gauge, estimate the height h: (a) without considering surface tension (b) with surface tension (capillary) effects. the contact angle can be assumed at 30 deg
Answers: 2
![image](/tpl/images/cats/fizika.png)
Physics, 22.06.2019 21:30, chasechevy13
Which of the following best describes the circuit shown below?
Answers: 3
Do you know the correct answer?
Questions in other subjects:
![Konu](/tpl/images/cats/istoriya.png)
![Konu](/tpl/images/cats/himiya.png)
![Konu](/tpl/images/cats/mat.png)
Mathematics, 31.10.2020 01:00
![Konu](/tpl/images/cats/en.png)
![Konu](/tpl/images/cats/mat.png)
Mathematics, 31.10.2020 01:00
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/istoriya.png)
![Konu](/tpl/images/cats/en.png)