A tiger paces back and forth along a rocky ledge. Its motion is shown on the following graph of horizontal position xxx vs. time ttt.
Graph of x (in meters) vs. t (in seconds). The y-intercept is at (0,0), then x increases linearly from 0 m to 2 m over 4 s, stays constant at 2 m from 4 to 8 seconds, and then decreases linearly from 2m to 0 m between 8 s and 12 s.
Graph of x (in meters) vs. t (in seconds). The y-intercept is at (0,0), then x increases linearly from 0 m to 2 m over 4 s, stays constant at 2 m from 4 to 8 seconds, and then decreases linearly from 2m to 0 m between 8 s and 12 s.
What is the average speed of the tiger between the times t=0\text{ s}t=0 st, equals, 0, s, end text and t=12{ s}t=12 st, equals, 12, s,

Search coils and credit cards. one practical way to measure magnetic field strength uses a small, closely wound coil called a search coil. the coil is initially held with its plane perpendicular to a magnetic field. the coil is then either quickly rotated a quarter-turn about a diameter or quickly pulled out of the field. (a) derive the equation relating the total charge q that flows through a search coil to the magnetic-field magnitude b. the search coil has n turns, each with area a, and the flux through the coil is decreased from its initial maximum value to zero in a time ∆t. the resistance of the coil is r, and the total charge is q = i∆t, where i is the average current induced by the change in flux. (b) in a credit card reader, the magnetic strip on the back of a credit card is rapidly “swiped” past a coil within the reader. explain, using the same ideas that underlie the operation of a search coil, how the reader can decode the information stored in the pattern of magnetization on the strip. (c) is it necessary that the credit card be “swiped” through the reader at exactly the right speed? why or why not?

The coefficient of friction is a number that represents the resistance to sliding between two in contact with one another.

Acentrifuge in a medical laboratory rotates at an angular speed of 3,700 rev/min. when switched off, it rotates through 54.0 revolutions before coming to rest. find the constant angular acceleration (in rad/s2) of the centrifuge. your response is within 10% of the correct value. this may be due to roundoff error, or you could have a mistake in your calculation. carry out all intermediate results to at least four-digit accuracy to minimize roundoff error. rad/s2