Physics
Physics, 15.04.2020 23:26, kelebsessoms89

A solar simulator is used to measure a 3-junction cell with area=0.27cm2. The simulator consists of 3 narrowband (laser) sources with the following wavelengths: 600 nm, 800nm and 1300nm. Assume the cells have band gaps of 0.67eV, 1.41eV and 1.88eV. What power is needed from each source to achieve a maximum Isc=1A

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 22.06.2019 12:30, decemberbooker2505
Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question
Answers: 1
image
Physics, 22.06.2019 13:00, maiahfogel1351
Which of the following are appropriate acceleration units?
Answers: 1
image
Physics, 22.06.2019 19:20, fernandofhn1844
Which best describes the difference between internal and thermal energy?
Answers: 1
image
Physics, 22.06.2019 23:30, queenbroookk
Newton's law of cooling states that the rate of change in the temperature t(t) of a body is proportional to the difference between the temperature of the medium m(t) and the temperature of the body. that is, startfraction dt over dt endfraction equals upper k left bracket upper m left parenthesis t right parenthesis minus upper t left parenthesis t right parenthesis right bracket , where k is a constant. let kequals0.04 left parenthesis min right parenthesis superscript negative 1 and the temperature of the medium be constant, m(t) font size decreased by 3 equivalent font size decreased by 3 294 kelvins. if the body is initially at 369 kelvins, use euler's method with hequals0.1 min to approximate the temperature of the body after (a) 30 minutes and (b) 60 minutes.
Answers: 2
Do you know the correct answer?
A solar simulator is used to measure a 3-junction cell with area=0.27cm2. The simulator consists of...

Questions in other subjects:

Konu
Mathematics, 05.10.2019 11:30