Physics
Physics, 14.04.2020 22:12, VICTURN3666

The density of mercury is 13.5 times greater than the density of water. If you were to build a barometer that used water instead of mercury to record the standard pressure at sea level, what would be the height of that barometer?

answer
Answers: 3

Other questions on the subject: Physics

image
Physics, 21.06.2019 18:30, iliketurtures
Three archers each fire four arrows at a target. joe’s four arrows hit at points 10 cm above, 10 cm below, 10 cm to the left, and 10 cm to the right of the center of the target. all four of moe’s arrows hit within 1 cm of a point 20 cm from the center, and flo’s four arrows hit within 1 cm of the center. the contest judge says that one of the archers is precise but not accurate, another archer is accurate but not precise, and the third archer is both accurate and precise. which description applies to which archer? explain
Answers: 2
image
Physics, 21.06.2019 20:40, cuavang55
In a steady-flow steam power plant system, two adiabatic high-pressure and low-pressure turbines ane used to generate power. superheated steam enters the high-pressure turbine at 8 mpa and 550°c. the steam expands in the high-pressure turbine to a saturated vapor at 3 mpa. in order to increase the powe generation of the power plant, another steam turbine working in a lower pressure ranges is deployed. the outlet vapor from the first turbine is heated up at a boiler to the temperature of 500 c at the constant pressure of first turbine's outlet (3 mpa). then, the vapor enters the second turbine and produces extra work. the exit conditions of the second turbine are 5o kpa and 90 percent quality. if the total power output of the power plant is 25 mw, determine a) the mass flow rate of the water (kg/s). b) heat transfer rate in the boiler (mw). (30 points) 3 mpa 00 c 8 mpa s0 c high pres turbine low pres boiler turbine 50 kpa 3 mpa 09 saturated vapor t heat engine, shown in the figure, operates between high temperature and low temperature of through a heat 4. a carnot tn and tu respectively. this heat engine receives energy from a heat reservoir at t exchanger where the heat transferred is proportional to the temperature difference as ? = k (z,-7, ). it rejects heat at a given low temperature tl. to design the heat engine for maximum work output, find the high temperature, th, as a function of tes and t. (15 points) qe
Answers: 3
image
Physics, 21.06.2019 22:30, mswillm
How many molecules are present in 3 mols of silicon dioxide (sio2)?
Answers: 1
image
Physics, 22.06.2019 09:50, trobbie817
A250-n box is at rest on a frictionless horizotal floor. then a person shoves the box with a non-zero force of magnitude p. which statement best describes the relationship betweeen p and the motion of the box after it was shoved? -the box will not move when p< 250n but otherwise will accelerate at a constant rate that is directly proportional to p - the box will begin moving at a speed that is directly proportional to p, then will gradually slow to a halt -the box will move with constant velocity at a speed that is directly proportional to p -box will accelerate across the floor at a constant rate that is directly proportional to p
Answers: 1
Do you know the correct answer?
The density of mercury is 13.5 times greater than the density of water. If you were to build a barom...

Questions in other subjects:

Konu
Mathematics, 04.10.2021 14:40
Konu
Mathematics, 04.10.2021 14:40
Konu
Social Studies, 04.10.2021 14:40