Physics, 14.04.2020 20:57, anaiyamills
What does it mean for waves to be absorbed by a certain medium? Make sure to include energy in your explanation.
Answers: 3
Physics, 21.06.2019 19:00, PONBallfordM89
What is tan(61)? Đ°. 1.80 b. 0.49 c. 0.61 d. 0.87
Answers: 1
Physics, 22.06.2019 00:00, faithcalhoun
How do the measurements of charge at the different locations on the sphere compare to each other? the charge measurements are different at all locations on the sphere. the charge measurements are virtually not the same at all locations on the sphere except for the charge at the very top and at the very bottom that are equal. the charge measurements are virtually the same at all locations on the sphere except for the charge at the very top. at the top, the conductive sphere has a small disk that is made of different material. the charge measurements are the same at all locations on the sphere. what happens to the charge on the conductive sphere when it is connected to a source of charge such as the electrostatic voltage source? nothing will happen because no charge goes around the surface of the sphere. the charge on the conductive sphere spreads out over the surface of the sphere; being greater in some specific locations on the sphere. the charge on the conductive sphere spreads out uniformly over the surface of the sphere. the charge on the conductive sphere spreads out non-uniformly over the surface of the sphere.
Answers: 3
Physics, 23.06.2019 17:30, jayp02
Wo dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).
Answers: 3
What does it mean for waves to be absorbed by a certain medium? Make sure to include energy in your...
Mathematics, 29.01.2021 07:30
World Languages, 29.01.2021 07:30
Chemistry, 29.01.2021 07:30
Mathematics, 29.01.2021 07:30
Mathematics, 29.01.2021 07:30