Physics
Physics, 09.04.2020 00:58, gbrightwell

Base your answer on The circuit diagram below which represents a circuit consisting of two resistors connected to a source of potential difference.

What is the total resistance of this circuit?

A)
5

B)
10

C)
20

D)
30

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 22.06.2019 00:00, gatornathan79
Phase changes are chemical changes. true or false
Answers: 1
image
Physics, 22.06.2019 01:10, caguil00
Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)
Answers: 3
image
Physics, 22.06.2019 02:00, honeybaby675610
Askydiver weighing 140 lb (including equipment) falls vertically downward from an altitude of 19,000 ft and opens the parachute after 18 s of free fall. assume that the force of air resistance, which is directed opposite to the velocity, is of magnitude 0.55|v| when the parachute is closed and is of magnitude 14|v| when the parachute is open, where the velocity v is measured in ft/s. assume that acceleration due to gravity has magnitude 32 ft/s/s; remember that weight is the product of mass and gravitational acceleration. (a) find the speed of the skydiver when the parachute opens. (b) find the distance fallen before the parachute opens. (c) what is the limiting velocity vl after the parachute opens? (d) determine how long the sky diver is in the air after the parachute opens. (e) plot the graph of velocity versus time from the beginning of the fall until the skydiver reaches the ground.
Answers: 1
image
Physics, 22.06.2019 04:50, jojoblue2004
Unpolarized light whose intensity is 1.19 w/ is incident on a polarizer. (a) what is the intensity of the light leaving the polarizer? (b) if the analyzer is set at an angle of = 41.0∘ with respect to the polarizer, what is the intensity of the light that reaches the photocell?
Answers: 1
Do you know the correct answer?
Base your answer on The circuit diagram below which represents a circuit consisting of two resistors...

Questions in other subjects: