Physics
Physics, 08.04.2020 02:31, sdolina5

A cutting tool under microprocessor control has several forces acting on it. One force is , a force in the negative y-direction whose magnitude depends on the position of the tool. The constant is ααalpha = 2.35 N/m³. Consider the displacement of the tool from the origin to the point x= 2.60 m , y= 2.60 m.
Calculate the work done on the tool by if this displacement is along the straight line y=x that connects these two points.

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 19:40, gonzalezjacquel7975
An uplifted block of rock between two normal faults
Answers: 1
image
Physics, 22.06.2019 05:20, luceridiaaz
Alfred pushes on a heavy box, but cannot move it. the box has a lot of inertia motion friction gravity
Answers: 1
image
Physics, 22.06.2019 14:30, samone26
Which of the following changes will increase the capacitance of a parallel-plate capacitor? (there could be more than one correct choice.) a) increase the charge on the plates b) decrease the poten5al between the plates c) increase the potential between the plates d) introduce a dielectric material between the plates e) decrease the separation between the plates
Answers: 3
image
Physics, 22.06.2019 19:30, u8p4
Water is siphoned from a large tank and discharges into the atmosphere through a 50-mm diameter tube. the end of the tube is b = 2.6 m below the tank bottom which is a = 6.7 m deep, and viscous effects are negligible. determine the maximum height h over which the water can be siphoned without cavitation occurring. atmospheric pressure is 101.4 kpa, and the water vapor pressure is 1.79 kpa (absolute). report your answer in meters to two decimal places.
Answers: 1
Do you know the correct answer?
A cutting tool under microprocessor control has several forces acting on it. One force is , a force...

Questions in other subjects:

Konu
Mathematics, 21.04.2020 03:53
Konu
Mathematics, 21.04.2020 03:53