Physics
Physics, 07.04.2020 22:25, rachis

A student lab group is brainstorming the design of an experiment that uses a gas-filled balloon to determine how the temperature affects the volume of the gas. Which Post-it note describes the most effective design?

1) Inflate three different balloons to three different volumes. Get three different beakers and fill them with water having three different temperatures. Put the biggest balloon in the beaker with the hottest water and the smallest balloon in the beaker with the coldest water. Measure the volume of each balloon and the temperature of the water.
2) Inflate a balloon. Put it in a beaker of room temperature water. Measure the balloon’s volume and the temperature of the water. Place the same balloon in a beaker of very cold water. Wait 3 minutes. Measure the new volume of the balloon and the temperature of the water. Place the same balloon in a beaker of heated water. Wait 3 minutes. Measure the new volume of the balloon and the temperature of the water.
3) Inflate a balloon. Put it in a beaker of water. Measure the volume of the balloon and the temperature of the water. Inflate a different balloon. Put the balloon in the same beaker and measure volume and temperature. Repeat the procedure for a third balloon. Make sure that each balloon is inflated to a different volume each time you blow into it.
4)Inflate three different balloons so that they have different volumes. Prepare three beakers with water having a different temperature. Place the balloons in the water. Measure the volume of the water in the beaker and the temperature of the water in each beaker.

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 22.06.2019 07:20, raemyiajackson1
Use the information presented in the graph to answer the questions. which segments show acceleration? which segment indicates that the object is slowing down? what is the velocity of segment b? what is the acceleration of segment b?
Answers: 3
image
Physics, 22.06.2019 08:20, cutechickens13
A3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular? a 3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular?
Answers: 3
image
Physics, 22.06.2019 11:00, tdahna0403
Consider a system to be two train cars traveling toward each other. what is the total momentum of the system before the train cars collide?   kg • what must the total momentum of the system be after the train cars collide?   kg •  
Answers: 2
image
Physics, 22.06.2019 15:30, tiffuuu
At 20∘c, the hole in an aluminum ring is 2.800 cm in diameter. you need to slip this ring over a steel shaft that has a room-temperature diameter of 2.804 cm . 1. to what common temperature should the ring and the shaft be heated so that the ring will just fit onto the shaft? coefficients of linear thermal expansion of steel and aluminum are 12×10−6 k−1 and23×10−6 k−1 respectively.
Answers: 1
Do you know the correct answer?
A student lab group is brainstorming the design of an experiment that uses a gas-filled balloon to d...

Questions in other subjects:

Konu
Biology, 03.11.2020 19:40