Physics, 02.04.2020 18:35, musicismylove2340

Calculate the vibrational frequency, in cm-1, required to increase the energy of a hydrogen iodide molecule from the v=4 to the v=5 energy level Isotope masses (not average atomic masses found on the periodic table!) to three decimal places are taken from NIST (select Most Common Isotopes) and force constants from hyperphysics Do not use scientific notation when entering your answer Vibrational Frequency cm-1

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 11:30, ramirezzairap2u4lh

Water is siphoned from a large tank and discharges into the atmosphere through a 50-mm diameter tube. the end of the tube is b = 2.1 m below the tank bottom which is a = 7.4 m deep, and viscous effects are negligible. determine the maximum height h over which the water can be siphoned without cavitation occurring. atmospheric pressure is 101.4 kpa, and the water vapor pressure is 1.79 kpa (absolute)

Answers: 3

continue

Physics, 22.06.2019 16:50, dakotagorski05

Which is an example of an exothermic process?

Answers: 2

continue

Physics, 22.06.2019 20:30, cupcake3103670

Aball is thrown from the top of a building with an initial velocity of 21.9 m/s straight upward, at an initial height of 51.6 m above the ground. the ball just misses the edge of the roof on its way down, as shown in the figure. (a) determine the time needed for the ball to reach its maximum height. (b) determine the maximum height. (c) determine the time needed for the ball to return to the height from which it was thrown, and the velocity of the ball at that instant. (d) determine the time needed for the ball to reach the ground. (e) determine the velocity and position of the ball at t = 5.35 s.

Answers: 1

continue

Physics, 22.06.2019 22:50, mdg5605

The illuminance of a surface varies inversely with the square of its distance from the light source. if the illuminance of a surface is 120 lumens per square meter when its distance from a certain light source is 6 meters, by how many meters should the distance of the surface from the source be increased to reduce its illuminance to 30 lumens per square meter?

Answers: 3

continue

Do you know the correct answer?

Calculate the vibrational frequency, in cm-1, required to increase the energy of a hydrogen iodide m...