The frequency of a microwave is 1.2 x 10^9 hertz. what is the wavelength of the given problem.

0.25 m

Explanation:

Electromagnetic waves consist of oscillations of the electric and the magnetic field, oscillating in a plane perpendicular to the direction of motion the wave.

All electromagnetic waves travel in a vacuum always at the same speed, the speed of light, whose value is:

Microwave is an example of electromagnetic waves.

The relationship between wavelength and frequency for an electromagnetic wave is:

where

is the wavelength

 is the speed of light

f is the frequency

For the microwave in this problem,

So its wavelength is

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

conservation of mass

mass before something happens = mass afterwards