Physics, 23.03.2020 05:34, KariSupreme
For a final project in Seon’s physics class, students were instructed to build a water balloon launcher, write a hypothesis, and then carry out an experiment with the launcher. Considering that 90 degrees means launching the balloon straight up into the air and 0 degrees means launching it straight along the ground, Seon first wrote the hypothesis below.
If the angle at which the balloon is launched decreases from 90 degrees, then the distance that the balloon goes along the ground will increase, because more energy will go into pushing the balloon forward than upward.
Seon found that this was true until the angle reached about 45 degrees, and then the distance along the ground began to decrease again. Seon knows that he will need to write a new explanation, but he would like to conduct an experiment that is based on his original hypothesis, with one of the variables changed.
How could Seon rewrite his hypothesis to be a statement that will more likely be supported?
a. change the independent variable to “If the angle at which the balloon is launched increases up to 90 degrees . . .”
b. change the dependent variable to “If the angle at which the balloon is launched moves closer to 45 degrees . . .”
c. change the independent variable to “If the angle at which the balloon is launched moves closer to 45 degrees . . .”
d. change the dependent variable to “If the angle at which the balloon is launched increases to 90 degrees. . .”
Answers: 1
Other questions on the subject: Physics
Physics, 22.06.2019 00:30, Solany6426
Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).
Answers: 2
Physics, 22.06.2019 13:10, jaeana
1. the materials manager for a billiard ball maker must periodically place orders for resin, one of the raw materials used in producing billiard balls. she knows that manufacturing uses resin at a rate of 50 kilograms each day, and that it costs $.04 per day to carry a kilogram of resin in inventory. she also knows that the order costs for resin are $100 per order, and that the lead time for delivery is four (4) days.2. at what point should resin be reordered? a. 0 kilograms remainingb. 50 kilograms remainingc. 200 kilograms remainingd. 400 kilograms remaininge. 500 kilograms remaining3. if order size was 1,000 kilograms of resin, what would be the length of an order cycle? a. 0.05 daysb. 4 daysc. 16 daysd. 20 dayse. 50 days4. if the order size was 1,000 kilograms of resin, what would be the average inventory level? a. 50 kilogramsb. 200 kilogramsc. 500 kilogramsd. 800 kilogramse. 1,000 kilograms5. if the order size was 1,000 kilograms of resin, what would be the daily total inventory costs, excluding the cost of the resin? a. $5b. $10c. $20d. $25e. $40
Answers: 3
Physics, 23.06.2019 09:00, kalebrayburn62
When the acceleration of a mass on a spring is zero, the velocity is at a (fill in the blank) . when the velocity of a mass on a spring is zero, the acceleration is at a (fill in the blank) .
Answers: 1
Do you know the correct answer?
For a final project in Seon’s physics class, students were instructed to build a water balloon launc...
Questions in other subjects:
Business, 01.08.2019 19:30
Business, 01.08.2019 19:30
