Bulb ܣ is rated for 20W at 12V. Bulb ܤ is rated for 20W at 120V. The two bulbs are mistakenly mixed up so that bulb ܣ is connected to a 120V line and bulb ܤ is connected to a 12V line. a. Determine the power dissipated by Bulb ܣ while connected to the 120Vline. b. Determine the power dissipated by Bulb ܤ while connected to the 12Vline. c. Which bulb, if any, is more likely to burn out and why?

Using the free-body diagram, calculate the net force acting on the sled. is the sled in a state of dynamic equilibrium?

1. what is the relationship between wavelength and the penetrating power of an electromagnetic wave? a) the penetrating power has no relationship to the wavelength. b) the penetrating power increases as the wavelength increases. c) the penetrating power decreases as the wavelength increases. d) the penetrating power decreases as the wavelength decreases. 2. as ice melts and turns into water, the speed of sound through the material would most likely do what? justify your answer. a) the speed would not change because the material is always water. b) the speed of sound would increase because the density of water is less than that of ice. c) the speed of sound would increase because energy is added to ice in order to make it melt. d) the speed of sound would decrease because sound travels faster through solids than liquids. 3.which of these waves need a medium to travel through? a) sound b) x-rays c) infrared rays d) visible light

What is the ultimate purpose of the nuclear reaction in a nuclear power plant? -the reaction is used to create a magnetic field. -the reaction is used to create temperatures high enough to generate steam. -the reaction is used to create a high pressure system used to spin the turbine of the generator. -the reaction is used to prevent chain reactions. in a safety seminar at a nuclear power plant, a technician describes the procedure used if temperatures in the reactor become too high. what procedures should the technician describe? select all that apply. -more coolant will be pumped into the reactor. -the control rods will be taken out of the reactor. -the fuels rods will be lowered into the reactor. -the control rods will be lowered into the reactor. during a lab experiment demonstrating the relationship between pressure and water, mr. demming puts a beaker of water into a vacuum chamber. once the chamber is sealed, mr. demming turns the vacuum on. as the pump starts to take air out of the chamber, the air pressure inside drops relative to the pressure outside the chamber. after a few minutes, there is next to no air pressure in the chamber. what do you expect to observe in the experiment? -the beaker of water will crack. -the boiling point of the water will decrease and begin to boil at room temperature. -the boiling point of the water will increase, and will only boil at temperatures higher than 212 degrees f. -the liquid water will expand and spill out of the beaker since the air pressure no longer compresses the water molecules.