We are building a road, and at one place we need to make a turn with a radius of 25m. The coefficient of static friction between the rubber and the material we are using is 0.6.
(a) Assuming that the road is flat through the turn, what is the maximum speed a car could have and safely navigate the turn without sliding off the road?
(b) Instead of keeping the road flat, let's bank the turn a little bit, giving the road an angle of 20° above the horizontal. With the banked turn, what is the maximum speed a car could have and still make it around the turn without sliding?

Chapter 23, problem 075 the figure shows a geiger counter, a device used to detect ionizing radiation (radiation that causes ionization of atoms). the counter consists of a thin, positively charged central wire surrounded by a concentric, circular, conducting cylindrical shell with an equal negative charge. thus, a strong radial electric field is set up inside the shell. the shell contains a low-pressure inert gas. a particle of radiation entering the device through the shell wall ionizes a few of the gas atoms. the resulting free electrons (e) are drawn to the positive wire. however, the electric field is so intense that, between collisions with gas atoms, the free electrons gain energy sufficient to ionize these atoms also. more free electrons are thereby created, and the process is repeated until the electrons reach the wire. the resulting "avalanche" of electrons is collected by the wire, generating a signal that is used to record the passage of the original particle of radiation. suppose the radius of the central wire is 24 âµm, the inner radius of the shell 2.3 cm, and the length of the shell 14 cm. if the electric field at the shell's inner wall is 2.8 ă— 104 n/c, what is the total positive charge on the central wire?

Hen a gfci receptacle device is installed on a 20-ampere branch circuit (12 awg copper), what is the minimum volume allowance (in cubic inches) required for conductor fill for each conductor in the outlet box?

Ben (55kg) is standing on very slippery ice when junior (25kg) bumps into him. junior was moving at a speed of 8 m/s before the collision and ben and junior embrace after the collision. find the speed of ben and junior as they move across the ice after the collision. give the answer in m/s. describe the work you did to get the answer.