Physics
Physics, 27.02.2020 01:57, lydiapoetz5330

diameter of a wire is measured 0.236 cm with the help of a screw gauge. The least count of the screw gauge is 0.001 cm. Calculate the possible percentage error in the measurement

answer
Answers: 3

Other questions on the subject: Physics

image
Physics, 22.06.2019 08:20, cutechickens13
A3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular? a 3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular?
Answers: 3
image
Physics, 22.06.2019 14:30, raoufhanna
A58-kg boy swings a baseball bat, which causes a 0.140-kg baseball to move toward third base with a velocity of 38.0 m/s.
Answers: 2
image
Physics, 22.06.2019 16:10, Wemaybewrong
Amass weighing 24 pounds, attached to the end of a spring, stretches it 4 inches. initially, the mass is released from rest from a point 8 inches below the equilibrium position. find the equation of motion. (use g = 32 ft/s2 for the acceleration due to gravity.)
Answers: 1
image
Physics, 22.06.2019 17:00, marchellepenuliar
Sawyer is studying diffraction. he draws a diagram of a plane wave to show how light waves travel. which best describes sawyer’s error? the wave fronts should be perpendicular to the direction in which the waves move. the arrow showing the direction of movement of the waves should be pointing to the left. the arrow showing the direction of movement of the waves should be pointing downward. the wave fronts should be both parallel and perpendicular to the direction in which the waves move.
Answers: 3
Do you know the correct answer?
diameter of a wire is measured 0.236 cm with the help of a screw gauge. The least count of the screw...

Questions in other subjects: