Physics
Physics, 26.02.2020 06:52, MOMMYDORA

EXPERIMENT: MOTION GRAPHS

If anyone can answer these questions or at least bullcr4p it that would be helpful

Make a graph of the data. You may use a graphing program. Think about what data should be on the y-axis and the x-axis. Be sure to label each axis and note the units used in the measurements. Be sure to draw a smooth curve through the points. Do not just connect the dots. Upload your data and graph in the essay box below and answer the following questions.

Did the car travel at a constant speed?

What was the average speed of the car?

What are some practical applications for determining the motion of an object?

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:30, nolandh7940
The percent efficiency of a machine can never be 100% (or greater), because in the real world some energy is always converted into a. heat b. work c. input force d. output force
Answers: 1
image
Physics, 22.06.2019 06:10, crystalryan3797
Africtionless piston-cylinder contains 50 l of saturated liquid r-134a. the piston has a mass and an area resulting in an applied pressure of 500 kpa on the refrigerant. the refrigerant is now heated until its temperature rises to 70∘c. calculate the work (in kj) done during this process.
Answers: 3
image
Physics, 22.06.2019 10:50, afonseca73
Asheet of steel 1.5 mm thick has nitrogen atmospheres on both sides at 1200oc and is permitted to achieve a steady-state diffusion condition. the diffusion coefficient for nitrogen in steel at this temperature is 6 x 10- 11 m2 /s, and the diffusion flux is found to be 1.2 x 10-7 kg/m2 -s. also, it is known that the concentration of nitrogen in the steel at the high-pressure surface is 4 kg/m3 . how far into the sheet from this high-pressure side will the concentration be 2.0 kg/m3 ? assume a linear concentration profile.
Answers: 3
image
Physics, 22.06.2019 11:10, axxpjr12
Consider an insulating crystal, made up of layers of atoms. what form would you expect the temperature dependence of the phonon heat capacity to approach at extremely low temperatures if the interlayer coupling is i)very strong (rigid coupling), and ii) very weak. explain.
Answers: 3
Do you know the correct answer?
EXPERIMENT: MOTION GRAPHS

If anyone can answer these questions or at least bullcr4p it th...

Questions in other subjects: