Physics
Physics, 25.02.2020 16:56, hsernaykaw42

You are measuring the pressure with a sensor embedded in a bridge. The bandwidth of the sensor is only 30 Hz, which means it can only measure changes less than 30 times a second. However, there is a 60 Hz high power power line nearby that might affect the signal acquisition. To reduce the induced noise to minimum, which type of filter should be used?Design a filter that can filter out all the noises with a 10 kΩ resister.

answer
Answers: 1

Other questions on the subject: Physics

image
Physics, 21.06.2019 20:50, lokiliddel
An airplane flies eastward and always accelerates at a constant rate. at one position along its path it has a velocity of 34.3 m/s, it then flies a further distance of 40100 m and afterwards its velocity is 47.5 m/s. find the airplane\'s acceleration and calculate how much time elapses while the airplane covers those 40100 m.
Answers: 1
image
Physics, 21.06.2019 22:30, cocodemain
A1200 kg car traveling north at 10 m/s is rear-ended by a 2000 kg truck traveling at 30 m/s. what is the total momentum before and after the collision?
Answers: 3
image
Physics, 22.06.2019 01:20, slimgemmx
An engineer designs a roller coaster so that a car travels horizontally for 152 ft, then climbs 137 ft at an angle of 34.0° above the horizontal. it then moves 137 ft at an angle of 48.0° below the horizontal. if we take the initial horizontal motion of the car to be along the +x-axis, what is the car's displacement? (give the magnitude of your answer, in ft, to at least four significant figures and give the direction of your answer in degrees counterclockwise from the +x-axis.)
Answers: 1
image
Physics, 22.06.2019 03:10, joho38
Athin plate moves between two parallel, horizontal, stationary flat surfaces at a constant velocity of v = 7.5 m/s. the two stationary surfaces are spaced 4 cm apart, and the medium between them is filled with oil whose viscosity is 0.9 n·s/m2. the part of the plate immersed in oil at any given time is 2 m long and 0.5 m wide. if the plate moves through the mid-plane between the surfaces, determine the force required to maintain this motion. what would your response be if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top surface (h1)? if the plate moves through the mid-plane between the surfaces, the force required to maintain the motion will be n. if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top (h1) surface, the force required to maintain the motion would be n.
Answers: 2
Do you know the correct answer?
You are measuring the pressure with a sensor embedded in a bridge. The bandwidth of the sensor is on...

Questions in other subjects:

Konu
English, 20.09.2019 04:00