Physics, 21.02.2020 17:30, noahprice0519

A signal with characteristics of 1 MHz and 5V enters a high pass filter. The filter has R = 15kohm and C = 200pF. Calculate the output voltage of the filter [measured across the resistor]. Answer in millivolts (mV).

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 16:30, epunisa

In raising a 6200-n piano with a pulley system, the movers note that, for every 2.2 m of rope pulled down, the piano rises 0.12 m . ideally, find the force required to lift the piano.

Answers: 2

continue

Physics, 22.06.2019 08:40, kayleewoodard

Apulley system is used to lift a 2,000 newton engine up a distance of 3 meters. the operator must apply a force of 250 newtons to the chain of the pulley system to lift the motor. to lift the engine 3 meters, the operator must pull a total of 30 meters of chain through the pulley system. what is the value of di?

Answers: 1

continue

Physics, 22.06.2019 10:10, princeofpowerjr

Which branches of natural science include the study of an organism that lived 10 million years ago

Answers: 1

continue

Physics, 22.06.2019 21:40, iancuteodora30

Ahair dryer is basically a duct in which a few layers of electric resistors are placed. a small fan pulls the air in and forces it through the resistors where it is heated. air enters a 1200 w hair dryer at 100 kpa and 22°c and leaves at 47°c. the cross-sectional area of the hair dryer at the exit is 60 cm2. neglecting the power consumed by the fan and the heat losses through the walls of the hair dryer, determine (a) the volume flow rate of air at the inlet and (b) the velocity of the air at the exit.

Answers: 1

continue

Do you know the correct answer?

A signal with characteristics of 1 MHz and 5V enters a high pass filter. The filter has R = 15kohm a...