Steam is contained in a closed rigid container. Initially, the pressure and temperature of the steam are 15 bar and 240C, respectively. The temperature drops as a result of heat transfer to the surroundings. Determine the pressure at which condensation first occurs, in bar, and the fraction of the total mass that has condensed when the temperature reaches 100C. What percentage of the volume is occupied by saturated liquid at the final state?
Answers: 3
Physics, 22.06.2019 00:30, Solany6426
Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).
Answers: 2
Physics, 22.06.2019 05:30, kenisonpaigebosma
Can anybody me with this? ? (picture included.)
Answers: 1
Physics, 22.06.2019 16:40, jcblake
Beryl states that insulation with the smallest possible thermal conductivity is best to keep a house warm in winter, but worst for keeping a house cool in summer. sapphire insists the reverse is true: low thermal conductivity is good in the summer, but bad in the winter. which one, if either is correct? a. beryl, because low thermal conductivity results in low heat transfer. b. beryl, because low thermal conductivity results in high heat transfer. d. sapphire, because low thermal conductivity results in high heat transfer. e. neither, because low heat transfer is desirable both in summer and in winter.
Answers: 2
Physics, 22.06.2019 20:00, chantelljenkins2
Aturntable that spins at a constant 74.0 rpm takes 3.10 s to reach this angular speed after it is turned on. find its angular acceleration (in rad/s2), assuming it to be constant, and the number of degrees it turns through while speeding up.
Answers: 2
Steam is contained in a closed rigid container. Initially, the pressure and temperature of the steam...
Mathematics, 13.03.2020 00:02