Imagine that you place a piece of copper with an initial temperature of 20°c in contact with some liquid water with an initial temperature of 100°c. assume that the physical system consisting of the copper and the water is thermally isolated from everything else; i. e., they can only exchange energy with each other.
a) sketch two three-phase diagrams, one for each substance, and mark the initial state for each one. explain in a sentence or two how you can tell if either substance will undergo a phase change during the process of coming to thermal equilibrium. you do not need to do any calculations.

Achild throws a ball with an initial speed of 8.00 m/s at an angle of 40.0° above the horizontal. the ball leaves her hand 1.00 m above the ground. how long is the ball in flight before it hits the ground?

In a wind tunnel the speed changes as the cross sectional area of the tunnel changes. if the speed in a 6' x 6' square test section is 100 mph, what was the speed upstream of the test section where the tunnel measured 20' x 20'? use conservation of mass and assume incompressible flow. conservation of mass requires that as the flow moves through a path or a duct the product of the density, velocity and cross sectional area must remain constant; i. e., that ova-constant. a model is being tested in a wind tunnel at a speed of 100 mph if the flow in the test section is at sea level standard conditions, what is the pressure at the model's stagnation point? (a) the tunnel speed is being measured by a pitot-static tube connected to a u- tube manometer. what is the reading on that manometer in inches of water? (b) at one point on the model a pressure of 2058 psf is measured. what is the local airspeed at that point?

Agas is contained in a vertical, frictionless piston–cylinder device. the piston has a mass of 3.2 kg and a cross-sectional area of 35 cm2. a compressed spring above the piston exerts a force of 190 n on the piston. if the atmospheric pressure is 95 kpa, determine the pressure inside the cylinder.