Physics
Physics, 20.01.2020 17:31, joejoefofana

It is reasonable to assume that the bulk modulus of blood is about the same as that of water (2.20 gpa). as one goes deeper and deeper in the ocean, the pressure increases by 1.0*10^4 pa for every meter below the surface.

a) if a diver goes down 33.0 m (a bit over 100 ft) in the ocean, by how much does each cubic centimeter of her blood change in volume?

b) how deep must a diver go so that each drop of blood compresses to half its volume at the surface?

c) is the ocean deep enough to have this effect on the diver?
-yes/no?

answer
Answers: 1

Other questions on the subject: Physics

image
Physics, 21.06.2019 16:30, nyce36
You throw a baseball directly upward at time t = 0 at an initial speed of 12.3 m/s. what is the maximum height the ball reaches above where it leaves your hand? at what times does the ball pass through half the maximum height? ignore air resistance and take g = 9.80 m/s2.
Answers: 1
image
Physics, 21.06.2019 22:00, natethawsm
Na food processing facility, a spherical container of inner radius r1 5 40 cm, outer radius r2 5 41 cm, and ther- mal conductivity k 5 1.5 w/m · k is used to store hot water and to keep it at 100°c at all times. to accomplish this, the outer surface of the container is wrapped with a 800-w electric strip heater and then insulated. the temperature of the inner surface of the container is observed to be nearly 120°c at all times. as- suming 10 percent of the heat generated in the heater is lost through the insulation, (a) express the differential equation and the boundary conditions for steady one-dimensional heat conduction through the container, (b) obtain a relation for the variation of temperature in the container material by solving the differential equation, and (c) evaluate the outer surface tempera- ture of the container. also determine how much water at 100°c this tank can supply steadily if the cold water enters at 20°c.
Answers: 2
image
Physics, 22.06.2019 05:30, mlopezmanny5722
The a992 steel rod bc has a diameter of 50 mm and is used as a strut to support the beam. determine the maximum intensity w of the uniform distributed load that can be applied to the beam without risk of causing the strut to buckle. take f. s. = 2 against bucklin
Answers: 3
image
Physics, 22.06.2019 11:00, Silvanade
What is the measurement of how fast an object moves relative to a reference point?
Answers: 1
Do you know the correct answer?
It is reasonable to assume that the bulk modulus of blood is about the same as that of water (2.20 g...

Questions in other subjects:

Konu
Arts, 25.01.2021 23:10