Physics
Physics, 14.01.2020 05:31, frankcaroccio0203

Awater wave has a frequency of 2 hertz and a wavelength of 5 cm. calculate it speed

answer
Answers: 1

Other questions on the subject: Physics

image
Physics, 22.06.2019 00:30, Solany6426
Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).
Answers: 2
image
Physics, 22.06.2019 02:00, robert7248
An object has a weight of 500 on earth what is the mass of this object
Answers: 1
image
Physics, 22.06.2019 03:00, nkidder
An electric current is flowing through the cord below. what will happen to this current if a magnet is brought near the cord? a. the electric current will stop flowing. b. it will exert a force on the voltage. c. the resistance of the wire will decrease. d. it will exert a force on the electric current.
Answers: 2
image
Physics, 22.06.2019 05:10, zionnahl
Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.
Answers: 3
Do you know the correct answer?
Awater wave has a frequency of 2 hertz and a wavelength of 5 cm. calculate it speed...

Questions in other subjects:

Konu
Mathematics, 20.08.2021 06:20
Konu
Mathematics, 20.08.2021 06:20
Konu
Mathematics, 20.08.2021 06:20