Physics
Physics, 04.01.2020 03:31, habsofarah0

When you drive a car in a circle at a constant speed you are accelerating towards the center of your circular motion.

answer
Answers: 1

Other questions on the subject: Physics

image
Physics, 21.06.2019 18:00, Pumpkinputters
Awind turbine is initially spinning at a constant angular speed. as the wind's strength gradually increases, the turbine experiences a constant angular acceleration 0.173 rad/s2. after making 2870 revolutions, its angular speed is 132 rad/s. (a) what is the initial angular velocity of the turbine? (b) how much time elapses while the turbine is speeding up?
Answers: 1
image
Physics, 21.06.2019 20:40, cuavang55
In a steady-flow steam power plant system, two adiabatic high-pressure and low-pressure turbines ane used to generate power. superheated steam enters the high-pressure turbine at 8 mpa and 550°c. the steam expands in the high-pressure turbine to a saturated vapor at 3 mpa. in order to increase the powe generation of the power plant, another steam turbine working in a lower pressure ranges is deployed. the outlet vapor from the first turbine is heated up at a boiler to the temperature of 500 c at the constant pressure of first turbine's outlet (3 mpa). then, the vapor enters the second turbine and produces extra work. the exit conditions of the second turbine are 5o kpa and 90 percent quality. if the total power output of the power plant is 25 mw, determine a) the mass flow rate of the water (kg/s). b) heat transfer rate in the boiler (mw). (30 points) 3 mpa 00 c 8 mpa s0 c high pres turbine low pres boiler turbine 50 kpa 3 mpa 09 saturated vapor t heat engine, shown in the figure, operates between high temperature and low temperature of through a heat 4. a carnot tn and tu respectively. this heat engine receives energy from a heat reservoir at t exchanger where the heat transferred is proportional to the temperature difference as ? = k (z,-7, ). it rejects heat at a given low temperature tl. to design the heat engine for maximum work output, find the high temperature, th, as a function of tes and t. (15 points) qe
Answers: 3
image
Physics, 22.06.2019 12:30, cxmochaa
If you place a magnet under a clear dish, and sprinkle iron fillings over it, above what part of the magnet will most of the fillings gather
Answers: 2
image
Physics, 22.06.2019 17:20, shoobywee
You charge a parallel-plate capacitor, remove it from the battery, and prevent the wires connected to the plates from touching each other. when you increase the plate separation, what happens to the following quantities?
Answers: 1
Do you know the correct answer?
When you drive a car in a circle at a constant speed you are accelerating towards the center of your...

Questions in other subjects: