Physics, 24.12.2019 01:31, jahmya123

He drawing shows a plot of the force component f cos θ in the direction of the displacement s for one particular variable force, between a displacement of s = 0 m and s = d. what is the work done by the force when d = 7.32 m?

Answers: 3

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 09:20, Geo777

Question 11 of 13 (1 point) jump to question: a stairway, ladder, or ramp must be present in excavations in which of the following situations? a. all trenches must have access/egress b. the trench is more than 15 feet wide but only 1 ½ feet deep c. the trench is more than 4 feet deep and the devices must be within 25 feet of all workers

Answers: 1

continue

Physics, 22.06.2019 11:00, kayla65u

I'm thinking it's 2 you are asked to explain the earth's magnetic field. which is the best reply? 1. the earth's magnetic south is similar to the north pole of a magnet. 2. the earth's core has a strong magnetic charge similar to the south pole of a magnet. 3. the earth's geomagnetic south is similar to the south pole of a magnet. 4. the earth's magnetic charge is not centered at either pole; it varies based on location.

Answers: 1

continue

Physics, 22.06.2019 12:50, starr3971

Air is contained in a variable-load piston-cylinder device equipped with a paddle wheel. initially, air is at 400 kpa and 17°c. the paddle wheel is now turned by an external electric motor until 75 kj/kg of work has been transferred to air. during this process, heat is transferred to maintain a constant air temperature while allowing the gas volume to triple. calculate the required amount of heat transfer in kj/kg.

Answers: 2

continue

Physics, 22.06.2019 18:00, maren17

Air enters a gas turbine with two stages of compression and two stages of expansion at 100 kpa and 17°c. this system uses a regenerator as well as reheating and intercooling – the intercooler returns the air to the inlet temperature. the pressure ratio across each compressor is 4 ; 300 kj/kg of heat are added to the air in each combustion chamber; and the regenerator operates perfectly while increasing the temperature of the cold air by 20°c. determine the system’s thermal efficiency. assume isentropic operations for all compressor and the turbine stages and use constant specific heats at room temperature. (0.378)

Answers: 3

continue

Do you know the correct answer?

He drawing shows a plot of the force component f cos θ in the direction of the displacement s for on...