Determine the minimum dimension a to the nearest mm of the beam’s cross section to safely support the load. the wood has an allowable normal stress of σ allow = 12.8 mpa and an allowable shear stress of τ allow = 1.5 mpa .

Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?

Ajoint produces movement when its angle decreases. which type of movement is it?

Two horses begin at rest. after a few seconds, horse a is traveling with a velocity of 10 m/s west, while horse b is traveling with a velocity of 13 m/s west. which horse had a greater acceleration? a. horse a because its change in velocity was greater than horse b's in the same time. b. horse b because its change in velocity was greater than horse a's in the same time. c. horse b because its change in velocity was the same as horse a's, but it took less time. d. both horses had the same acceleration.