Physics
Physics, 31.01.2020 22:52, Neko1kat

Which of the following energy sources is in no way derived from the sun?
a) nuclear energy b)tidal energy c) wind energy d) petroleum

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 19:10, shazanah95
Athin, square metal plate measures 14 cm on each side and has emissivity of 0.60. the plate is heated to a temperature of 745°c. what is the rate at which the plate radiates energy ? the stefan-boltzmann constant is 5.67 × 10-8 w/(m2 ? k4). remember that the plate will radiate energy from both its top and bottom surfaces.
Answers: 1
image
Physics, 22.06.2019 03:50, am2garcia5
A30 kg weight lies on top of a massless piston of area a = 0.01 m2 the exterior air is at a (constant) p =1 atm and t = 27 c. the interior gas is 0.4 moles of (ideal) n2 and it has initial temperature 27.00 degrees c. 1. what is the initial pressure in the interior? a. 29.4 kpa b. 130.7 kpa c. 101.3 kpa the next three questions concern what happens when an amount of heat q is slowly added to the interior, raising the piston by 1 mm and raising the interior temperature to 27.40 c
Answers: 3
image
Physics, 22.06.2019 23:00, sagereagin
Which type of reaction is shown in this energy diagram ?
Answers: 1
image
Physics, 23.06.2019 02:10, Nathaliasmiles
Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what “x” and “y” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is “smooth”.
Answers: 1
Do you know the correct answer?
Which of the following energy sources is in no way derived from the sun?
a) nuclear energy b)t...

Questions in other subjects:

Konu
Geography, 24.09.2019 15:10
Konu
History, 24.09.2019 15:10
Konu
Social Studies, 24.09.2019 15:10