Areducing elbow in a horizontal pipe is used to deflect water flow by an angle θ = 125° from the flow direction while accelerating it. the elbow discharges water into the atmosphere. the cross-sectional area of the elbow is 150 cm2 at the inlet and 25 cm2 at the exit. the elevation difference between the centers of the exit and the inlet is 40 cm. the mass of the elbow and the water in it is 52 kg. determine the anchoring force needed to hold the elbow in place. take the momentum-flux correction factor to be 1.03 at both the inlet and the outlet. the density of water is 1000 kg/m3, and the flow rate of water is 30 kg/s.

Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question