(a) how high a hill can a car coast up (engine disengaged) if work done by friction is negligible and its initial speed is 110 km/h? (b) if, in actuality, a 750-kg car with an initial speed of 110 km/h is observed to coast up a hill to a height 22.0 m above its starting point, how much thermal energy was generated by friction? (c) what is the average force of friction if the hill has a slope 2.5º above the horizontal?

(a) the high of a hill that car can coast up (engine disengaged) if work done by friction is negligible and its initial speed is 110 km/h is 47.6 m

(b) thermal energy was generated by friction is 1.88 x J

(C) the average force of friction if the hill has a slope 2.5º above the horizontal is 373 N

Explanation:

given information:

m = 750 kg

initial velocity, = 110 km/h = 110 x 1000/3600 = 30.6 m/s

initial height, = 22 m

slope, θ = 2.5°

(a) How high a hill can a car coast up (engine disengaged) if work done by friction is negligible and its initial speed is 110 km/h?

according to conservation-energy

EP = EK

mgh =

gh =

h =

  = 47.6 m

(b) If, in actuality, a 750-kg car with an initial speed of 110 km/h is observed to coast up a hill to a height 22.0 m above its starting point, how much thermal energy was generated by friction?

thermal energy = mgΔh

                         = mg (h - )

                         = 750 x 9.8 x (47.6 - 22)

                         = 188160 Joule

                         = 1.88 x J

(c) What is the average force of friction if the hill has a slope 2.5º above the horizontal?

f d  = mgΔh

f = mgΔh / d,

where h = d sin θ, d = h/sinθ

therefore

f = (mgΔh) / (h/sinθ)

 = 1.88 x /(22/sin 2.5°)

 = 373 N

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).