Physics
Physics, 19.11.2019 07:31, mazolethrin6876

6. if your were an astronaut doing a spacewalk outside the space shuttle orbiting the earth,
would you be:
mass-less?
yes or no
weight-less?
yes or no
inertia-less?
yes or no

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:00, sophiamoser
In a wind tunnel the speed changes as the cross sectional area of the tunnel changes. if the speed in a 6' x 6' square test section is 100 mph, what was the speed upstream of the test section where the tunnel measured 20' x 20'? use conservation of mass and assume incompressible flow. conservation of mass requires that as the flow moves through a path or a duct the product of the density, velocity and cross sectional area must remain constant; i. e., that ova-constant. a model is being tested in a wind tunnel at a speed of 100 mph if the flow in the test section is at sea level standard conditions, what is the pressure at the model's stagnation point? (a) the tunnel speed is being measured by a pitot-static tube connected to a u- tube manometer. what is the reading on that manometer in inches of water? (b) at one point on the model a pressure of 2058 psf is measured. what is the local airspeed at that point?
Answers: 2
image
Physics, 22.06.2019 01:30, kaylin28
Astone is dropped with no initial velocity from the top of a cliff and hits the ground a time of 3.9 s later. what is the height of the cliff, in units of meters? you may assume that air resistance is negligible. give the answer as a positive number question 15 a figure skater is rotating at a rate of 200 revolutions per minute. what is the angular speed, in units of rad/s? 200 o 20.9 12000 o 3.33
Answers: 2
image
Physics, 22.06.2019 11:30, lifeofabe214
Why is the energy that results from a roller coaster's position at the top of a hill referred to as potential energy?
Answers: 1
image
Physics, 22.06.2019 12:00, angelamirga332
Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.
Answers: 1
Do you know the correct answer?
6. if your were an astronaut doing a spacewalk outside the space shuttle orbiting the earth,
w...

Questions in other subjects:

Konu
Mathematics, 02.07.2021 01:50
Konu
Mathematics, 02.07.2021 01:50